Installation onto grass

HI-THICK - INSTALLATION ONTO GRASS

Resistant to attack from mould, moss and verdigris treatments. Easy and quick installation even by nonprofessional operators. The installation does not require special equipment or tools.

Posa su Erba



JAPANESE STEPS

Posa su ErbaThis type of installation increases the stability of the slab onto the grass support.

How to lay the “japanese steps”

To carry out a floor with Japanese style steps, it is necessary to define the number of steps to complete the pathways and lay the slabs so that they are equidistant from each other. It is recommended to install the slabs so that they do not overhang the grass level. This will prevent damage to grass-cutting machinery when trimming the grass.


A)HITHICK
B)Grass bed
C)Gravel 5/6 cm (Granulometry 4-8 mm)
D)SCHLUTER®-BARA-RT (it further increases stability: optional)
E)Geo-fabric
F)Ground
G)Gravel mix (ratio 1:8 with gravel >= 4 mm)


 

HOW TO LAY THE “JAPANESE STEPS”

PassiGiapponesi_1PassiGiapponesi_21) Lay the slabs at the same distance one from the other.
2) Mark the perimeter of the slab onto the
grass bed.
3) Lift the slab from the ground.
4) Dig the ground for 5-6cm.

 

 


PassiGiapponesi_3

 PassiGiapponesi_45) Add the gravel (fine granulometry 4-8 mm).
6) Place the slab.
7) Tap the surface of the slab using a rubber hammer.

 

 


NOTE:

The layer-graphs shown are merely indicative: it is recommended to refer to  the specific norms of your country to carry out state-of-the-art flooring.


 Attention!
The installation mode may vary depending on country regulations.
Download and read the full documentation of HI-THICK before installing the product. 

PDF NOT valid for this market: USA, Canada e Oceania  -  PDF Valid ONLY for USA, Canada and Oceania.